First layer seems to start well, but then gets messy – How do I

Not sure what would be causing this. I've cleaned the bed, and I've done live Z adjust, could this be a result of "wet" filament? I live in the midwes

AnkerMake Explore the 3D Printing Frontier - Ankermake Canada

Why does my top layer look so bad? The rest of the print is perfect : r/3Dprinting

What to do when filament sticks to nozzle surfaces

First Layer Messy : r/Ender3S1

5 Simple Steps to a Perfect First Layer

Any idea what causes this pilling and mess on the first layer? – Assembly and first prints troubleshooting – Prusa3D Forum

Better First Layer and Bed Level Fixes on 3D Printers

First layer super clean, next layers rough. What gives? : r/FixMyPrint

System Design Case Study #1: Implementing Caching In A Distributed Architecture. How DoorDash Did It In Their Microservices Architecture