Rugged Metal Pushbutton with Blue LED Ring [16mm Blue Momentary
Adafruit Industries, Unique & fun DIY electronics and kits Rugged Metal Pushbutton with Blue LED Ring [16mm Blue Momentary] : ID 481 - These chrome-plated metal buttons are rugged and look real good while doing it! Simply drill a 16mm hole into any material up to 1/2" thick and you can fit these in place, there's even a rubber gasket to keep water out of the enclosure. On the front of the button
These chrome-plated metal buttons are rugged and look real good while doing it! Simply drill a 16mm hole into any material up to 1/2" thick and you can fit these in place, there's even a rubber gasket to keep water out of the enclosure. On the front of the button is a flat metal actuator, surrounded by a blue plastic LED ring. On the back there are 3 contacts for the button (common, normally-open and normally-closed) and 2 for the blue LED ring (+ and -). Connect 3 to 6V to the LED to have it light up nicely, there's a built in resistor! If you want to use this with a higher voltage, say 12V or 24V, simply add a 470 ohm resistor in series with the LED connection to keep the LED current at around 20mA.
16mm High Current IP67 Rated Waterproof Push Button Switches, Industrial Pushbutton Switches Electronics Manufacturer
Metal Pushbutton - Momentary (16mm, Blue) - COM-11967 - SparkFun Electronics
Vision-LED Module-Accessories - Eckstein Shop
Rugged Metal On/Off Switch with Green LED Ring - 16mm Green On&Off Who
Search Results for buttons
Wiring a Push Button Switch with LED ring light
Rugged Metal Pushbutton - 16mm 6V RGB Momentary
Rugged Metal Pushbutton - 19mm 6V RGB Momentary : ID 3425 : Adafruit Industries, Unique & fun DIY electronics and kits
Latching: Press the button-ON, Press the button again-OFF; Electrical life: 100, 000 times, Mechanical life: 500,000 cycles High current: 20Amp
16mm Heavy Duty Latching Metal Push Button Switch Waterproof Anti-Vandal Large Current 20Amp 12V-24V ON-Off 1NO 4 Pins with Pre-Wired Socket for 5/8