First Layer Issues - Creality K1 Max - 3D Printing Space
I’ve been all over the place with this machine so far, and this is where I am now. Any suggestions as to what direction I should be heading are appreciated. Rooted K1 Max/Orcaslicer/Duramic PLA/0.4mm nozzle @230⁰/speed: 50mm/retraction: 0.5mm @ 60mm second My starting flow ratio is 0.99 and my line width was at 0.34mm. I am playing with my Z offset and flow rate on the Fluidd interface as I go with these. The filament is dry. The flow settings shown on the pic are relative to the starting po
K1 first layer help : r/crealityk1
Creality K1 Review: CoreXY For Tinkerers
Prime Day: Enhance Your Maker Tools and Save With the New Creality K1 Max 3D Printer
Prime Day: Enhance Your Maker Tools and Save With the New Creality K1 Max 3D Printer
K1 Max 3D Printer, 3Ding
Creality K1 Max (300x300x300mm) AI Speedy 3D Printers
K1 first layer help : r/crealityk1
Creality K1 Max (300x300x300mm) - 3D Printing USA
.png)
Creality K1 Max 3D Printer Australia
The Best Creality K1 Mods & Upgrades of 2023
Creality K1 and K1 Max 3D Printer Review: Expected Speed with Unexpected Quality - CNET
