Live Tailstock Drill Chuck Kit with Chuck Reversing Adapter for Woodtu
Complete Live Tail stock Drill Chuck Kit is the perfect solution for aligning and supporting a turning for bottom finishing on a woodturning lathe.
Complete Live Tail stock Drill Chuck Kit is the perfect solution for aligning and supporting a turning for bottom finishing on a woodturning lathe.
The video below demonstrates this kit being used with a vacuum chuck.
This kit includes the following:
Live (rotating) 1/2 keyed drill chuck with MT2 mount. Fits most wood lathe tail stocks.
1 - Chuck Reversing Adapter with either 1-8 or 1 1/4-8 threads. Choose size with radio buttons.
1 - 1/4 diameter x 4 length center point
1 - 3/8 diameter x 4 length center point
1 - 1/2 diameter x 4 length center point
1 - 3/4 diameter x 1½ length center point
6 - Non marking vinyl caps used over the flat end of the center points. Sizes 1/4, 3/8 and 1/2
The flat end of the center points covered with these caps are used to eliminate the center point mark in the bottom of a turning.
1 - Chuck key
Allows precision centering and holding of your work at the tail stock end of your wood lathe.
Very useful to support small diameter work where a live center is not practical.
Ideal for holding the chuck reversing adapter, mandrels, dowels and tenons up to 1/2 dia.
The shank is 2 Morse taper. The drill chuck has 1/2 capacity.
Videos – Harrison Specialties
One of the handiest lathe accessories you can have, this drill chuck can be used for both turning and drilling applications., To use in the headstock
Drill Chuck with Morse Taper Adapter
Zip Trim Portable Garden Grass Trimmer Cordless Mini Trim Strimmer
Complete Live Tail stock Drill Chuck Kit is the perfect solution for aligning and supporting a turning for bottom finishing on a woodturning lathe.,
Live Tailstock Drill Chuck Kit with Chuck Reversing Adapter for Woodturning Lathe MT2
Live Tailstock Chuck Adapter - 1 x 8 TPI – Turners Warehouse
Nova chuck use LumberJocks Woodworking Forum
Wood Lathe Carbide Woodturning Tools
Live 1/2 Tailstock Drill Chuck #2MTGet precision centering and griping of your work at the tailstock end of your lathe. Ideal for holding mandrels,
Live 1/2 Tailstock Drill Chuck #2MT
Woodturners 3-Jaw Micro Chuck at Penn State Industries
1-1/4 x 8 TPI threads. Make sure your lathe spindle matches that thread size. Unscrew your chuck from the lathe headstock without removing your
Chuck reversing adapter for wood turning lathe 1-1/4 x 8 TPI
Wood Lathes at
4 Inch Wood Lathe Chuck Set 1 x 8 tpi, Self Brazil
Wood Lathe Carbide Woodturning Tools
JET JWL-1015 10 X 15-1/2 Wood Lathes
Packard Woodworks: The Woodturner's Source: Tailstock Chuck Reversing Adaptors